Voice Commands - SonoSite SonoRemote Control Guia Del Usuario

Voice commands

WARNING: To avoid unexpected system responses
to voice commands, test them before
the ultrasound procedure. See
the voice commands"
If the remote control fails to respond to
voice commands during an ultrasound
procedure, use the buttons instead.
You can control the ultrasound system by
speaking commands into a microphone
connected to the remote control. Before using
voice commands, train the remote control to
recognize your voice.
Whenever you connect the microphone, the
remote control is automatically ready for voice
commands.
See also "Reviewing the cine buffer" on page 7.
To connect the microphone
Insert the microphone connector into the
microphone port. See Figure
The microphone indicator turns on. The
remote control beeps three warning beeps if
not previously trained.
To train the remote control
You can train the remote control with your own
phrases instead of the default phrases in this
procedure. See "Using custom phrases" on
page 7.
Read the entire procedure before beginning.
Allow enough time for training: about 15 to
30 minutes. If you have to stop for more than a
few seconds during training, disconnect the
microphone and begin again.
1 Set up the equipment and environment:
a In a quiet area, turn on the remote control.
b Connect the microphone.
c Put on any garments, such as a mask or
gown, that will be between your mouth
and the microphone during ultrasound
procedures.
6 Controlling the ultrasound system
"To test
on page 7.
2 Start training mode: Press
3 Say and then repeat each phrase in the
1 on page 2.
4 Test the voice commands.
d Attach the microphone to your clothing,
near your mouth and where positioned
during ultrasound procedures (for
example, under the gown).
and then release. If the remote control beeps
three times, clear the memory (within
10 seconds) by pressing
beep.
The microphone indicator starts blinking.
If these responses do not occur, disconnect the
microphone and restart the procedure.
following table, in order, and wait for the
response.
Saying each phrase in order associates it with
the correct response from the ultrasound
system.
Use the same volume and clarity that you use
during ultrasound procedures.
Say: Wait for: Repeat: Wait for:
Depth
1 beep
up
Gain
2 beep
down
Gain
3 beep
up
Depth
4 beep
down
5 Freeze beep
6 Save beep
The long beep indicates that the training is
complete.
until the beep,
until the long
Depth
2 beeps
up
Gain
2 beeps
down
Gain
2 beeps
up
Depth
2 beeps
down
Freeze 2 beeps
Save long beep