General Standards - Lamborghini Caloreclima ECO 3 Manual Para La Installación Y El Mentenimiento

GENERAL STANDARDS

This manual is an integral and essential part of the product and must be given to the
installer.
Read the warnings given in this manual as they supply important indications regarding
instal-lation, use and maintenance safety.Keep this manual carefully for future referen-
ce. The burner must be installed in compliance with the Standards in force, according
to the manufacturer's instructions and by qualified staff Incorrect installation can cause
injury/damage to persons, animals or objects, for which the manufacturer cannot be
held responsible.
This appliance must only be destined for the use for which it was expressly declared.
Any other use must be considered improper and therefore dangerous.The manufac-
turer is not liable for any damage caused by improper, incorrect or unreasonable use.
Before carrying out any cleaning or maintenance, disconnect the appliance from the
mains power supply by acting on the system switch or via the relevant shut-off ele-
ments.
In the case of breakdown and/or bad functioning of the appliance, deactivate it and do
not at-tempt repairs or direct interventions.
Only contact qualified professional staff.Any product repairs must only be performed
by an after-sales centre authorised by the manufacturer, using original spare parts.Fai-
lure to comply with the above can compromise appliance safety.In order to guarantee
the efficiency of the appliance and its correct functioning, it is indispen-sable to follow
the manufacturer's indications.
Have qualified professional staff perform periodic maintenance of the appliance.Whe-
never the appliance is no longer to be used, the parts that may become a potential
source of danger must be made harmless.
Before commissioning the burner, have qualified staff check:a) that the plate data are
those requested by the gas electricity mains supplies;b) that burner calibration is com-
patible with boiler power;c) that the flow of combustion agent air and the evacuation
of flue gases take place correctly according to Standards in force;d) that aeration and
normal maintenance of the burner are guaranteed.
Before performing any intervention that envisions disassembly of the burner or ope-
ning of the inspection access points, disconnect the electric current.
Do not deposit containers of inflammable substances in the room where the burner is
situa-ted.
UK
26