Preparation - hager S771-22X Manual De Instalación

Preparation

Lift up the cover.
¡ Remove the fixing plate from the base by sliding it
downwards.
Using a sharp object (pen nib, screw, rigid copper
¬
wire) punch through the membranes to make holes for
the cables.
Membranes
To guarantee tight fitting:
• make the hole as small as possible (this can be
done using a needle),
• if several conductors need to be threaded through
the hole these should be bunched together to form
a cylindrical cross-section (10 mm maximum Ø).
√ Remove the fixing plate washer and position it at the
top of the plate as shown.
Draw a cable up to where the external receiver is to
ƒ
be located.
≈ Remove about 40 mm of cable sheath then strip
each conductor along 8 to 10 mm.
The maximum conductor diameter must be
between 2.5 mm
connection).
119
(or 4 mm for the earth
2 2
G
B