Publicidad
Solución de problemas
Problem
Abnormal vibration.
Will not vacuum or has poor
vacuum performance
Engine will not start. (Starter
does not turn)
Engine will not start. (Starter
turns)
Engine is locked, will not pull
over.
Engine will not stay running
Pieza núm. 791166-SP
Manual del propietario de DL25
Possible Cause
Loose or out of balance impeller or
loose engine
· Nozzle buried in debris. Clogged
hose or exhaust. Excessive quantity of
debris.
Battery is low or dead. Battery Cable is
disconnected or battery terminal is
corroded. Harness wire is bad or
disconnected from interlock switch.
Hose not installed, allowing interlock
wire to ground.
· Throttle & / or stop switch in off
position. Out of gasoline. Bad or old
gasoline. Spark plug wire
disconnected. Dirty air cleaner.
· Debris locked against impeller.
Engine problem.
Oil reservoir overfilled
10
Solution
Check impeller and replace if necessary.
Check engine.
· Withdraw nozzle from debris pile.
Unclog hose or exhaust (see pg. 11)
Allow air to feed debris.
Charge battery or replace if the battery
does not hold charge. Clean battery
terminal and cable then reconnect. Install
hose coupler securely to the unit and
check whether interlock switch is
engaged by lever. Check harness wire
connection and replace if necessary.
· Check stop switches, throttle, and
gasoline. Connect spark plug wire. Clean
or replace air cleaner. Or contact a
qualified service person.
· See pg.11, Clearing a clogged impeller
housing. Contact an engine servicing
dealer for engine problems.
Drain oil and refill to correct level.
Formulario núm. F090513B
Publicidad
