Klein Tools LAN Scout Jr. Manual De Instrucciones página 3

7
1
2
3
4
Pass: "Pass" illuminates if the cable is a properly wired 4-pair
1.
T568A/B data cable or cross-over (uplink) cable. A cross-over
cable will have the pin numbers of the crossed pairs flashing and
will alternate with "C".
Cable Faults: The "Miswire" icon illuminates if the cable is not
2.
wired to one of the cabling standards. An open or short error takes
precedence over miswires and the appropriate icon(s) illuminates.
The "Split" icon illuminates if the designated pairs are not twisted
together in the cable, an AC signal fault.
3. Tester-End Wire Map: The top line displays the pins on the tester
end in order. These pins are mapped to the pins on the remote-end
shown directly below them on the LCD.
4. Remote-End Wire Map: The bottom line displays the
corresponding pin on the remote-end. Dash lines on the remote
line indicate shorted pins. No pin numbers displayed on the remote
line are open pairs.
5. Battery Low: The battery low symbol illuminates when the
battery is nearing depletion. The symbol will begin to flash
when the battery needs to be replaced. Results may be unreliable
at this point.
6. Shield: The "S" icon illuminates when a shielded data cable is
properly connected at both ends. It will be flashing if there is a
short to a wire in the cable along with that pin number and the
"Short" indicator.
7. Voltage Detected Warning: If voltage is detected on any of the
tester connectors, the "Voltage!" icon illuminates. A check for
voltage is performed before each test and if found, no test is run.
The tester should be disconnected immediately from the source
of the voltage.
DISPLAY
5
6
3