General Information; Low Battery Indicator; Replacing The Battery - Southwire 41161N Instrucciones De Operación

GENERAL INFORMATION

Low Battery Indicator

When the battery voltage drops below approximately 2.7V, the red POWER
LED will begin flashing once every 2 seconds to indicate that the batteries
need to be replaced. When this occurs, you should replace the batteries
immediately. If the battery voltage falls below 2.4V, the voltage tester will
beep 5 times and then immediately turn off.

Replacing the Battery

WARNING:
To avoid electric shock, remove test leads from the
voltage tester before removing the battery cover.
1. Remove the one Phillips screw from the battery cover located on the
back of the 41161N voltage tester.
2. Remove the battery cover.
3. Install two (2) new AAA batteries.
4. Re-install the battery cover and tighten the screw. Be careful not to over
tighten the screw.
WARNING:
To avoid electric shock, do not operate your tester
without the battery cover in place and fastened securely.
17
SPECIFICATIONS
AC: 12, 24, 48, 120, 208, 240, 277, 480, 600
Voltage LED Steps
DC: 9, 12, 24, 36, 48, 60, 110, 220, 400
Safety Rating
CAT IV 600V, Class 2, Double Insulation
AC Frequency Range
50Hz/60Hz
Operating Temperature
32°F to 104°F (0°C to 40°C)
Storage Temperature
14°F to 122°F (-10°C to 50°C)
Relative Humidity
Max 85％ RH (NC)
Altitude
≤6560 feet (2000m)
Drop Protection
6.5 feet (2 meters)
Safety Rating
CAT IV 600
NCV Detection Range
100V AC to 1000V AC
Battery Type
2-AAA, 1.5V each
18