Flex MS713 Instrucciones De Funcionamiento Originales página 17

MS713
2. Position one (115 mm) wide end,of a
115 mm x 140 mm piece of sandpaper,
under the open paper clamp (1.), and
hold, while Iifting paper clamp Iever up
and placing it behind the locking tab to
secure the paper in place (2.).
3. Open second paper clamp (as described
in Step 1).
4. Stretch the sandpaper tight over the
pad (1.), position the loose end under
the second paper clamp, and close paper
clamp (2.).
5. Punch holes in paper (for dust extraction),
as instructed in „Paper punch" section of
this manual.
Paper punch
A Paper Punch is provided with the Model
MS713 Sander.
The punch is used to make eight holes
through the abrasive. These holes allow the
sanding dust to be extracted directly through
the pad. The punch can be mounted to a
workbench or wall using 2 flat head screws.
Use the punch as follows:
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug!
1. lnstall the abrasive to the sandar as
described in the „Attaching hook & loop
abrasive" section,or the „Attaching
conventional abrasive" section of this
manual.
2. Position the sander to the punch, aligning
the sander pad with the two corner guides
on the punch. Push sander onto the
punch until seated.
3. Remove sander from punch.
17