Technibel CWX 6 Instrucciones De Instalacion Y Utilizacion página 21

5 - FRAME / GRILLE INSTALLATION
• The frame / grille comes in a separate box (code K 70 N
094 T) for CWX 6, (code K 70 N 095 T) for CWX 8/10.
• Before installing the facade:
- Remove the retaining screws (1) from the locks (2) on
each side (remember to replace these screws after
installation).
- To open the grille (3), turn the two locks (2) in the
direction of the arrow.
- Open the grille (3) 45°.
- Detach the safety cord (4) from the frame (remember to
replace it again after installation).
- Pull the grille inward to remove it from the frame.
• To install the facade:
- Turn the two locking clips (5) downward.
- Attach the frame of the facade (6) to the unit with the
two hooks (7) by lining them up with the locking clips
(5).
Observe the position of the facade frame as the hooks
are not the same size. Correctly present them in front of
the corresponding locking clips.
- Check the correct position of the facade frame in
relation to the false ceiling. Adjust the position of the
internal unit, as required.
- Secure the facade frame to the unit using the special
screws and washers (8) provided.
- Fit the grille (3) making sure that the filter (9) is correctly
installed.
- Hook the grille safety cord to the frame, close the grille
and replace the lock retaining screws.
1
2
4
5
6
7
8
GB
3
3
5
9
3
9