Omega Lift Equipment 44010 Manual De Piezas E Instrucciones De Funcionamiento página 5

ASSEMBLY
Model 44020:
1. Make sure all parts are present (refer Fig. 2 & 4). If any parts are missing or damage, contact customer service.
2. Attach swivel casters (15) to rear extension legs (24) with bolts, washers & nuts (27, 23 & 22).
3. Slide front extension legs (14) and rear extension legs (24) into base (11), secure with bolts (13) into base, tighten
bolts.
NOTICE: Never adjust leg extensions beyond factory marked position on each leg. Adjust each leg extension an
equal distance from the base.
4. Place upright (2) on the base (11) and secure with bolts (13). Leave bolts finger tight.
5. Attach braces (18) on each side of upright at top and secure with bolt & nut (4 & 19). Place bottom of braces to
inside of base, and secure with bolts & nuts (29 & 19).
6. Attach bracket (5) to hydraulic unit (1) with bolts, washers & nuts (6, 25 & 26).
Then attach the assembly to upright mounting ears using bolt & nut (10 &12).
7. Place boom (7) on top of upright (2) and secure with bolt & nut (3 & 20). Pump hydraulic unit using handle (21) until
ram extends approximately 2". Place boom mounting bracket on top of ram and secure with bolt & nut (9 & 12).
8. Slide boom extension (8) into the boom (7), ensure the slot for chain faces down and secure with bolt & nut (9 & 12)
in correct hole on boom for your particular job. Four positions available: 1/2 ton, 1 ton, 1 1/2 ton and 2 ton.
9. Slide chain and hook (17) through slot in lower front of boom extension (8) and secure with bolt & nut (28 & 19)
as shown. Retighten all fasteners.
Item
Figure 4 - Assembly Illustration for Model 44020
5
Hardware Kit Component
3 Bolt M20 x 120
4 Bolt M12 x 100
6 Bolt M10 x 30
9 Bolt M16 x 90
10 Bolt M16 x 75
12 Nut M16
13 Nut M12 x 25
19 Nut M12
20 Nut M20
22 Nut M8
23 Lock Washer M8
25 Nut M10
26 Lock Washer M10
27 Bolt M8 x 16
28 Bolt M12 x 75
29 Bolt M12 x 90
Qty
1
1
2
2
1
3
6
4
1
16
16
2
2
16
1
2