Crown LPS-800 Manual Del Operacion página 6

Wiring
BRIDGE-MONO WIRING USING THE SPEAKON
Bridge-mono mode doubles the output power of the amplifier.
1. See Figure 5. On the back panel, set the Output Mode Switch to BRIDGE.
2. Wire the speaker to the Speakon
3. Only the Channel 1 Volume Control works in Bridge-mono mode.
BRIDGE-MONO WIRING USING THE BINDING POST CONNECTORS
Bridge-mono mode doubles the output power of the amplifier.
1. See Figure 6. On the back panel, set the Output Mode Switch to BRIDGE.
2. Wire the speaker to the Binding Post connectors as shown.
3. Only the Channel 1 Volume Control works in Bridge-mono mode.
page 6
®
CONNECTORS
®
connector as shown.
Figure 5. Bridge-Mono Wiring With Speakon
Figure 6. Bridge-Mono Wiring With Binding Post Connectors
LPS Series Power Amplifiers
®
Connectors
Operation Manual
+
2
1
–
3
Input signal
+
2
1
–
3
Input signal