Crown LPS-800 Manual Del Operacion página 7

LPS Series Power Amplifiers
Wiring
PARALLEL WIRING USING THE SPEAKON
With this wiring, a signal sent to Channel 1 is paralleled to both channels so that it is reproduced by both speakers.
1. See Figure 7. On the back panel, set the Output Mode Switch to PARALLEL.
2. Wire the speakers to the Speakon
Channel 1
Loudspeaker
Bottom
Speakon
(Channel 2)
PARALLEL WIRING USING THE BINDING POST CONNECTORS
With this wiring, a signal sent to Channel 1 is paralleled to both channels so that it is reproduced by both speakers.
1. See Figure 8. On the back panel, set the Output Mode Switch to PARALLEL.
2. Wire the speakers to the binding post connectors as shown.
Operation Manual
®
CONNECTORS
®
connectors as shown.
Top Speakon
(Channel 1)
Channel 2
Loudspeaker
Figure 7. Parallel Wiring With Speakon
Figure 8. Parallel Wiring With Binding Post Connectors
®
Connectors
+
2
1
–
3
Input signal
+
2
1
–
3
Input signal
page 7