Rear View And Description - HeiTel CamServer 2c Guía De Instalación Rápida

HeiTel Digital Video GmbH - Quick Installation Guide CamServer 2c

Rear view and description

Item Labelling/description
1 V in
2 V out
3 24 pin
terminal block
4 Ethernet
5 eSATAp
6 RF, antenna terminal
7 GPS, antenna terminal
8 USB
Pin assignment
terminal block
Labelling/
Pin
description
1 RS-485–
2 RS-485+
⊥
3 PTZ
4 RS-232 Tx
5 RS-232 Rx
18
1 2
3
Function
Video input 1: BNC socket for connecting colour or B/W video. Switching between
CCIR/PAL and EIA/NTSC mode is automatic.
Video output 1: Active loop through output - BNC socket - for direct connection of
additional video systems/monitors.
Terminal block with screw type terminals: Terminals for power supply, PTZ control
interfaces, control inputs, relay outputs, loudspeakers (optional).
Socket RJ-45: Ethernet interface (10/100 MBit/s)
eSATAp port: combined eSATA port with integrated USB power supply (Power Over
eSATA)
Antenna terminal (SMA) for 3G/UMTS mobile network (only in combination with 3G/
GPS Module)
Antenna terminal (SMA) for GPS signals (only in combination with 3G/GPS
USB port, type A: reserved for other applications
Connection of an additional IP camera or of the two maximum possible
IP cameras is effected via the Ethernet interface. It may be necessary for a
switch to be interconnected.
24 pin terminal block
1
13
Type Function
Serial (D–) Use this terminal to connect up to 2 remote control cameras (1× analogue
and 1× IP or 2× IP; each RS-485) or other compatible devices (e.g. matrix)
Serial (D+)
with RS-485/RS-422 interfaces.
Ground Common ground for RS-232 interface
Serial TxD Use this terminal to connect 1 remote control camera or one other
compatible device (e.g. matrix) with RS-232 interface.
Serial RxD
4 5 6 7 8
12
24
Module)
CamServer 2c