Remington R300 Instrucciones De Operación página 6

Safety precautions
7. An operator taking medi-
cation should take extra
precautions while handling
the tool. nEVEr drink al-
coholic beverages or take
medications which impair
your vision, balance, or
judgement before using a
powder actuated tool.
KnOW YOUr FaStEnInG BaSE matErIaL
Sinks in
with
average
hammer
blow
tOO SOFt
Surface
shatters
tOO BrIttLE
1. aLWaYS know the thickness and type of base material
into which you are fastening. nEVEr GUESS. Test the
base material by using the Center Punch Test. The Center
Punch Test is performed by using a hammer to test drive
the particular power fastener to be used into the material.
If the point penetrates easily, the material is too soft. If the
point becomes blunt, the material is too hard. If the material
fractures, cracks or shatters, the material is too brittle. Test
fastenings can be made if the material shows a clear power
fastener impression and the power fastener point is not
blunted. aLWaYS start with the lowest power load (Gray-
Level 1) and proceeding with the order shown in the lower
right-hand figure above. Operators and bystanders must
aLWaYS wear goggles and ear protection which meet or
exceed the accepted standards for adequate protection
in your country. In the USA, refer to ANSI standards. In
Canada, refer to CSA standards.
?
?
?
?
6
?
?
?
CENTER
PUNCH TEST
Point
flattens
tOO HarD
Start
1
GRAY
BROWN
3 4
GREEN YELLOW
2
119586