POWER REGULATOR 3
Put the selector SW2 on the card of the first power regulator as per the drawing
•
press button P1 on the card
•
press the red ON button within 2 seconds
•
press the red OFF button within 2 seconds
B.If the programming is unsuccessful, repeat the programming process.
HOW TO USE THE REMOTE CONTROL
Once the remote control has been programmed, proceed as follows:
SINGLE REMOTE CONTROL for making adjustments in one zone: press the red ON button, then
adjust the power by pressing the buttons MIN (red LED) – MED (orange LED) – MAX (green LED).
When it is first turned on, the power regulator will go to minimum (red LED) by pressing the ON
button. Press the red OFF button to shut it off.
MULTICHANNEL REMOTE CONTROL up to 3 zones for multiple power regulators: press the
green ON button relating to channel L1 or L2 or L3. T o adjust the power, press the buttons MIN
(red LED) – MED (orange LED) – MAX (green LED).
When it is first turned on, the power regulator will go to minimum (red LED) by pressing the ON
button. Press the green OFF button relating to channel L1 or L2 or L3.
MAINTENANCE
The STAR6 power regulator does not require any maintenance. However, it does need to be
cleaned on occasion using a dry anti-static cloth. Caution: Make sure to disconnect STAR6 from
the mains before performing any cleaning tasks. Do not clean using sharp instruments.
TECHNICAL DA TA
•
220-240V power supply
•
50/60 Hz Frequency
•
Maximum load 6000 Watt (resistive loads only)
•
Room temperature -20°/+30°
•
Protection rating IP56
•
Soft start
•
Dimensions mm 210 height x 180 x 57 thickness
•
UP TO 5 REMOTE CONTROLS CAN BE PROGRAMMED FOR EACH power regulator
Radio features
•
433 MHz radio frequency
•
3 channels for max 5 regulators each
•
Remote control configuration: via radio with internal button
•
Heater adjustments: MIN – MED - MAX
POWER REGULATOR 3
14