Description Of The Front Panel - Aqua Isipool pH L3 Manual De Instalacion Y Uso

3.0 ISIPOOL PROGRAMMING

3.1 Description of the front panel

3.2 Isipool standby / operational
To enter standby mode:
Press and hold the "Down" button for about 5 seconds until the display switches off. The red LED
"pausa" will blink to show the unit is powered in standby mode/
To return to operational mode:
Briefly press the "Down" button. The display will light up and the instrument is ready for redox
control.
3.3 Default settings:
- pH set point 7,4 pH
- Acid Dosing to decrease the pH
12/05/2010
If the light is:
Fixed green, the pH is correct
Blinking green, the pump is dosing
Fixed red, the pump is in calibration mode
Blinking red, there is an error
The display shows:
The pH value
The state of the calibration
The alarms
Shows if the filtration is active or not:
The red point is blinking = the filtration is not active
The red point is not lit up = the filtration is active
Increase the desired pH value (with the SET button)
Alkaline or acid dosing option (with the SET button)
Decrease the desired pH value (with the SET button)
Alkaline or acid dosing option (with the SET button)
Put in stand by / work the Isipool
Allows to show the setpoint
Allows to change the set point
Allows to change the dosing in Alkaline or acid
Allows to do the calibration of the probe
Aqua Water Systems Ltd
Stourport-on-Severn - Worcestershire - DY13 9QB - UK
Telephone: 044 1299 827703 - Fax: 044 1299 827704
Email: sales@askaqua.co.uk
17