Recommended Spare Parts; Troubleshooting; Additional Information About Special Versions "B1" And "Asbestos - Nilfisk 3707 Manual De Instrucciones

3707 - 3907 - 3907 L, M, H - 3907/18 - 3907/18 L, M, H
3707/10 - 3707/10 L, M, H - 3907 W - 3907 W L, M, H
Cartridge kit (fig. 22)
Item Code
TS2 Z8 391107

Recommended spare parts

The following is a list of spare parts that should be kept ready to
hand in order to speed up maintenance work.
List of recommended spare parts
Pos. Description
1 Star filter "L"
2 Star filter "M"
3 Filter ring
4 Filter ring seal
5 Filter clamp
Upstream Hepa filter
6
"H"
Downstream Hepa
7
filter
8 Container / Lid

Troubleshooting

Fault
The vacuum suddenly
stops
Dust leaks from the
vacuum
GB
The vacuum blows
instead of sucking
Electrostatic current
on the vacuum
C65
Description
Timer
Figure 23
Mod. Dimensions
Ø 560
Ø 560
Ø 560
Ø 560
Ø 560
Ø 400x400
475x610x292
Ø 460
Causes Remedies
Clogged main filter Shake the filter.
Replace it if this is not
sufficient
Clogged suction hose Check the suction
hose and clean it
Motor protector tripper Check the setting.
Check the power draw
of the motor. Contact
an authorized after-
sales service centre if
necessary
The filter is torn Change it with
another of identical
category
Inadequate filter Change it with
another of a suitable
category and check
Incorrect connection Remove the plug and
to the electricity main invert two of the live
wires
Non existent or Check all earth
inefficient earthing connections.
Particularly check the
suction inlet Lastly,
the hose must be
strictly antistatic
Additional information about special versions
"B1" and "Asbestos"
Q.ty
A. Type B 1 Industrial Vacuum Cleaners (Edition 06.98)
1
- Zone 22
WARNING!
1. Only genuine, authorized hoses and accessories may be
used.
2. Extension cables, adapters or electric plug reducers must
not be used.
3. Type "B1" industrial vacuum cleaners are technically
suitable for cleaning up dry flammable dust in Zone 22.
Dusts with an extremely low flammability energy (MZE
Code No.
<1mJ) are excluded.
8 17081
Use of the appliance with this type of dust requires a
8 17246
specific safety inspection in conjunction with further
8 15005
provisions if required. The appliances are therefore not
8 17027
suitable for vacuuming on unmanned machines.
8 18081
4. The container must be emptied when required and always
after each use.
8 17264
5. If the motor turns in the wrong direction, e.g. caused by
an incorrect polarity of the mains, the appliance must be
8 17093
stopped immediately to prevent critical conditions from
8 40275
being caused by the blowing action working in the opposite
direction, or by overheating.
6. When the industrial vacuum cleaner operates in both
normal and abnormal conditions, certain parts of it can
become as hot as 135°C (e.g. the Motor).
7. Type "B1" industrial vacuum cleaners are not suitable
for vacuuming or extracting explosive dust or equivalent
substances, as established in par. 1 of the "German
Law for explosive substances", or liquids, or mixtures of
combustible dust with liquids.
8. All parts of the vacuum cleaner are grounded to prevent
electrostatic charges.
9. During maintenance work and when the filter is replaced,
periodically check to make sure that the PE ground cables
are undamaged and correctly fixed.
14
01/2015