Playing Audio From An External Device; Using The Radio - Denon Professional DN-300Z Guia Del Usuario

Playing Audio from an External Device

To play audio on an external device (e.g., smartphone, computer, portable music
player, etc.) connected to the Aux In:
1. If the unit is off, press the Power Button to power it on.
2. Connect the 1/8" (3.5 mm) stereo/headphone output of your external device to the
Aux In.
3. Select AUX as the media type (described in
If your external device is connected, AUX Connected will appear in the display. If
your external device is not connected, AUX Disconnect will appear in the display.
4. To start playback, press the Play button on your external device.
Important:
All buttons except for Power and Media will be locked/disabled.
When AUX Disconnect is shown in the display, inserting a CD will cause the unit to
enter CD Mode automatically.

Using the Radio

To use the radio:
1. If the unit is off, press the Power Button to power it on.
2. Select FM or AM as the media type (described in
broadcast will start automatically.
Important: Make sure you have properly connected the FM and AM antennae and set the Tuner Region Select
Switch to the correct setting, as described in the
3. To select a radio station, use the Tuning Buttons on the unit or remote control. To jump to the previous or next
station with clear reception, press and hold the button for more than 1 second.
In FM/AM Mode, you can perform any of the following operations:
• To turn Auto Mute on or off, press the Auto Mute button on the unit or remote control. When enabled, a station
will be muted if its reception is not clear enough, and Low Signal will appear in the display.
• To select a station's preset number, turn the Jog Dial on the unit, or press one of the Skip Buttons on the
remote control.
Alternatively, press one of the Number Buttons (0–9) on the unit or remote control to enter the desired preset
number. If the preset number is two digits, press the buttons in succession (e.g., 1 then 2 for Preset 12) within 1
second.
• To save a station to a preset number:
1. Select the desired station.
2. Press the Memory button on the unit or remote control.
3. Use the Number Buttons (0–9) on the unit or remote control to enter the desired preset number.
4. Press the Jog Dial on the unit, or the Enter Button on the remote control. When the station is saved
successfully, Stored will appear in the display. (This will overwrite the station previously saved to that preset
number)
14
Selecting the Media Playback
Selecting the Media Playback
Setup / Connection
Mode).
Mode). The audio from the
Diagram.