Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
You will need:
•
A water heater set to deliver 120°F (49°C) water to the washer.
•
A grounded electrical outlet located within 6 ft. (1.8 m) of where the power cord is attached to the back of
the washer. Refer to "Grounding Instructions" on page 4.
•
Hot and cold water faucets located within 4 ft. (1.2 m) of the hot and cold water fill valves, and water
pressure of 20-100 psi (137.9 - 689.6 kPa) .
•
A level floor with a maximum slope of 1" (25 mm) under entire washer. DO NOT install the washer on soft
floor surfaces, such as carpets or surfaces with foam backing.
•
A sturdy and solid floor to support the washer with a total weight (water and load) of 200lbs.
•
DO NOT operate your washer in temperatures below 32°F (0°C) . Some water can remain in the washer and
can cause damage in low temperatures.
INSTALLATION CLEARANCES
•
The location must be large enough to allow the washer door to be fully opened.
•
Additional spacing should be considered for ease of installation and servicing. The door opens more than 90°
and it is NOT reversible.
•
Additional clearances might be required for wall, door and floor moldings.
•
Additional spacing of 1" (25mm) on all sides of the washer is recommended to reduce noise transfer.
•
Companion appliance spacing should also be considered.
RECOMMENDED SPACING FOR UNDER-COUNTER INSTALLATION
2.0" (50 mm)
33.5"
(850 mm)
1.0" (25 mm)
23.5" (595 mm)
11
Figure 4
1.0" (25 mm)
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
