Datalogic STAR Modem Guía Rápida página 12

STAR MODEM™
Position 1 = RS232/Digital interface
Position 2 = Wedge/Pen Emulation interface
STAR Modem™ configuration can be performed in three ways: by using the
DL Sm@rtSet software configuration program, by sending configuration strings from
the Host via the RS232 interface or by reading configuration barcodes with a
Datalogic RF device and sending the commands to STAR Modem™ via radio.
DL Sm@rtSet
DL Sm@rtSet is available on the STAR Modem™ CD-ROM and can be installed on
your PC.
DL Sm@rtSet is a Windows-based utility program providing a quick and user-friendly
configuration method via the RS232 interface.
It also allows upgrading the software of the connected device (see the DL Sm@rtSet
User's Manual for more details).
Configuration Strings
STAR Modem™ initial setup must be performed via serial interface by sending the
configuration strings to the modem using any terminal emulation program, for
example Hyper Terminal.
Ensure that your PC COM port is set as follows:
9600 baud, no parity, 8 data bits, 1 stop bit, handshaking disabled.
NOTE
The programming sequence is the following:
$+
6
Screws
Command $-
Character sequence in following tables
Enter configuration environment
Position 2
CR
Carriage return character (0D Hex.)
Exit and Save configuration
Position 1