Datalogic STAR Modem Guía Rápida página 14

STAR MODEM™
INTERFACE SELECTION
Select the desired interface string for your application, then set the correct hardware
jumper position (see "STAR Modem™ Initial Setup" for jumper setting).
Among the following interface selection strings, send only the string that suits
your application:
RS232 Interface
Pen Emulation Interface
Wedge Interface
IBM AT or PS/2 PCs
IBM XT
PC Notebook
IBM SURE1
IBM Terminal 3153
IBM Terminals 31xx, 32xx, 34xx, 37xx
To select the interface for these IBM Terminals, send the correct KEY
TRANSMISSION string. Select the KEYBOARD TYPE if necessary (default =
advanced keyboard).
ALT MODE
The ALT-mode selection allows barcodes sent to the PC to be interpreted correctly
independently from the Keyboard Nationality used. You do not need to make a
Keyboard Nationality selection.
(default = Num Lock Unchanged).
Make sure the Num Lock key on your keyboard is ON.
Wyse Terminal - ANSI Keyboard
Wyse Terminal - PC Keyboard
Wyse Terminal - ASCII Keyboard
Wyse Terminal - VT2200 style Keyboard
APPLE ADB Bus
Digital Terminal VT2xx/3xx/4xx
8
Make-only keyboard
Make-break keyboard
Advanced keyboard
Typewriter keyboard
IBM AT- ALT mode
PC Notebook - ALT mode
$+CP0$-CR
$+CP6$-CR
$+CP500$-CR
$+CP503$-CR
$+CP505$-CR
$+CP506$-CR
$+CP504$-CR
$+CP502$-CR
$+CP501$-CR
$+FK1$-CR
$+FK0$-CR
$+CP507$-CR
$+CP508$-CR
$+CP509$-CR
$+CP510$-CR
$+CP511$-CR
$+CP514$-CR
$+CP513$-CR
$+CP512$-CR
Jumper
Position
1
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
1