Initial Setup; Reversing The Winch Handle - TRUSST CT-CS60 Guía De Referencia Rápida

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
TRUSST® QRG

Initial Setup

Reversing the Winch Handle

1. Place the Crank Tower in the vertical position.
2. Locate the winch handle.
3. Use a wrench to remove the 16 mm nut and washer, located at the top of the arm.
4. Reverse the handle arm as in the pictured example.
5. Replace the washer and nut, and tighten with a wrench.
· Ensure the ground is firm enough to prevent any sinking of the Crank Tower.
· The stability of the Crank Tower is of prime importance to ensure all safety and winch
features function properly.
TRUSST® recommends the placement of 3/4" thick plywood pads under the tower base and
leg feet, if using the tower on a soft surface or where damage to the flooring may be a concern.
16 mm nut and washer
4
EN

Publicidad

Tabla de contenido
loading

Productos relacionados para TRUSST CT-CS60

Tabla de contenido