Technical Specifications - Rosewill R-W320-T Manual Del Usuario

IR REMOTE CONTROL BENDER
Insert the plug of the IR probes [F] into the IR probes output connection [B]
at the back of the IR bender [A].
Insert the plug of the IR receiver extension [E] into the IR receiver extension
input connection [C].
Install the IR bender flat on a horizontal surface within sight and reach of
your remote control (± 6m in ideal circumstances) or inside the cabinet.
Stick the IR receiver extension preferably onto a vertical surface, next the
IR eye of the TV set.
Lead the IR probes inside the cabinet and to the A/V equipment. In such
way that a LED can be stuck onto the IR eye of each A/V apparatus. Test
the position of each LED first before sticking as this should be done
carefully and precisely.
Insert the plug of the PSU into the PSU input connection [D] at the back of
the IR bender. Only use the supplied PSU. Connect the PSU to the mains.
Use your remote control and point towards the IR receiver extension within
an angle of ± 15° in all directions.
Important remark: In some cases, the receiver can suffer from interference
and not pick up the signal from your remote control. Interference can be
caused by devices in the direct vicinity such as dimmers and lamps, or by
direct sunlight. If such is the case, reorient or relocate the IR receiver, or
increase the distance between the IR receiver and the device causing the
interference.

6. Technical Specifications

Powering
power consumption
operating range
IR receiving range
Dimensions
Weight
Use this device with original accessories only. Cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For
more info concerning this product, please visit our website. The information in
this manual is subject to change without prior notice.
R-W320-T
9VDC/100mA through PSU
Max. 1W
± 6m (ideal circumstances)
30 ~ 60kHz
62 x 95 x 35mm
292g
6
User Manual