U.S.Robotics USR5441 Guía De Instalación Rápida página 6

B. Connect the supplied Ethernet cable to the LAN port of the Wireless MAXg Range Extender
and to a LAN port on a networking device, such as a router.
existing router
C. Connect the power adapter to the Wireless MAXg Range Extender and to a standard wall
power outlet.
existing router
Note to UK Users: Attach the correct power plug to the power adapter.
Step Two: Locate the Range Extender in your network
Note: It is recommended that the Wireless MAXg Range Extender is always configured via
an Ethernet connection. This will ensure the configuration changes are made without mod-
ifying the properties of any wireless cards in your network.
Windows Users
A. Insert your U.S. Robotics Installation CD-ROM into the CD-ROM drive of a computer con-
nected to the existing router. The Installation CD User Interface will appear on your screen.
If prompted, select your preferred language. Follow the on-screen instructions to install and
launch the Detection Utility.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run, type
D:\setup (or the appropriate letter of your CD-ROM drive), and click OK.
B. When the Detection Utility opens, follow the on-screen instructions.
C. After the devices on your network are detected, determine which is your Range Extender by
matching the LAN MAC addresses. The LAN MAC address of the Range Extender is located
on the label on the bottom of the Range Extender. If you do not see the LAN MAC address for
your Range Extender, make sure it is connected properly and click Detect to scan your net-
work again. Select the LAN MAC address for your Range Extender and click Next.
D. Click Finish to exit the Detection Utility and to open the Web User Interface in a new browser
window.
2
B
Wireless MAXg Range Extender
Wireless MAXg Range Extender
C