Publicidad
Idiomas disponibles
Idiomas disponibles
WAITING CALL FROM FDU
ESC
5. Wait until the outside call position emits a single beep, then press the call key that
you want to associate with the video entryphone. Every old association with other
apartment units will be deleted.
confirmation, re-enable the learning mode in the apartment unit.
6. Press the
key on the video entryphone. The video entryphone beeps to confirm
the success of the logic connection, and you will see the word "CONFIGURED" on
the screen.
The green LED corresponding to the assigned intercom number (the internal
intercom number of the apartment) will light up.
7. If there are other video entryphones in the apartment, that need to be logically connected
to the same push-button of the front door unit, repeat steps 4-6 for each of them.
When associating other devices with the same push-button of the front door unit,
they automatically adopt the first number available (2, 3 or 4) for the internal
intercom.
: each push-button of the front door unit can manage up to 4 devices
per apartment units (the upper limit for an apartment).
: if additional apartment units are added to a push-button at a later
moment, it will also be necessary to reconfigure the devices of that apartment that
have already been programmed, respecting the previous programming order.
8. Repeat the procedure from point 4 in order to connect the next push-button of the
front door unit to the corresponding video entryphone.
9. After configuring all the necessary push-buttons of the front door unit (if the total
number of push-buttons is greater than that of the apartments, you do not need to
configure the extra ones), switch off the audio/video module of the front door unit,
take it out of the Programming mode by turning switch 1 of DIP switch 2 to OFF,
then switch the device back on again.
10. If the system has another outside call position, repeat the entire procedure (from
point 1) with that position as well.
11. At the end of the procedure, switch all the apartment units off then back on again.
18/01/2010
12:00
ENTER
if the front door unit does not receive the
126
The video entryphone will go
into standby until it receives
a call from the front door unit
(FDU).
Publicidad
