Canon RS-CL17 Manual De Instalación página 10

5
Pull cables out of the cable hole in
the ceiling
● As depicted in the diagram, let cables pass
through the hole on ceiling-mount clamp.
● If cables are too thick, make a hole at a different
position than the hole on the ceiling-mount
clamp, and let them pass through the new hole.
Attach the Joint fitting to the
6
Ceiling-mount bracket
Secure the Ceiling-mount bracket using
the four M5 screws (A) removed from the
Ceiling-mount bracket during preparation.
Hook the Base bracket to the Joint fitting and secure it temporarily
7
Hook the Base bracket on the protrusion (D) of the Joint fitting, and secure it temporarily using
the four M5 screws (B) removed earlier.
● Pull out the cables.
● Firmly tighten the screws (B) after adjusting the projection angle as explained in page 13.
B
8
Connect cables
Connect cables to the projector.
After completion of installation, adjust
the projection angle (page 13).
8
A
D
A
Direction to the
screen
B