Assembly And Installation; Installation To Flat And Level Ceiling - Canon RS-CL17 Manual De Instalación

Assembly and Installation

Installation to flat and level Ceiling

Preparation:
Separate the Joint fitting from the
Ceiling-mount bracket temporarily
Remove four M5 screws (A) to separate
Joint fitting from the Ceiling-mount bracket.
1
Make a hole in the ceiling
● Make holes to install the Ceiling-mount bracket
using Template Sheet (T3).
● Make wiring holes.
● Download the template sheet (T3) from the URL
below, and print it in the actual size (100%).
http://www.canon.com/lcd-sim/
● The direction to the screen and the light axis (lens center) is indicated on the template sheet
(T3).For regular installation (adjusting legs side facing down), use SIDE A of the template
facing toward the direction of the screen. For inverse installation (adjusting legs side facing
up), use SIDE B of the template facing toward the direction of the screen.
Caution
2
Secure the Ceiling-mount bracket to
the ceiling
Use four M13 screws, to secure the Ceiling-
mount bracket to the ceiling with the arrow
facing toward the screen.
● Before securing the Ceiling-mount bracket, be
sure to remove the template sheet (T3).
● The M13 screws are not included in the supplied
parts. Prepare the M13 screws suitable for the
ceiling structure.
3
Attach the Base bracket to the
projector
1 Remove M6 nuts from the arm units.
Then, remove M6 spring washers and
M6 washers.
● The remaining M6 washers (4 pcs)
will be used in Step 4-1 (2 pcs) and
Step 4-4 (2 pcs).
Caution
Attach arm plate A and M6 washers to
arm plate B. Insert them into the holes on
the four corners of the base bracket, and
temporarily tighten them with M6 spring
washers and M6 nuts (4 positions).
A
A
Direction to the
screen
A
Direction to the
screen
B
5