Fleck ELECTRONIC SXT Serie Manual De Uso página 24

2 - PROGRAMMING
2.1.10 Regeneration cycles
The settings 10.1 to 10.4 enable the regulation of the regeneration cycle times.
The amount of cycles is established by the piston type.
ex.: Backwash
Brine draw and slow rinse
Brine refill
2.1.11 Define days of regeneration in the week
Only viewed in 7 days time clock mode [dAY]
This parameter is identified by the letter D. It allows you to select the days of the week that
trigger regeneration. If every day is set to OFF, the valve does not regenerate and displays an
error code Err2 after 8 days. To clear this error display: settle at least one day of the week and /
or trigger a manual regeneration.
Note: the electronic will require at least one day to be set on.
ex.: - regeneration on Monday
- no regeneration on Tuesday and Wednesday
- regeneration on Friday
Input the current day of the week in order for the valve to work correctly.
ex. : day of installation Thursday
2.1.12 Meter Type
Not viewed in time clock mode
This parameter is identified by the letters FM.
- [ t 0.7] :
- [P 0.7] :
- [ t 1.0] :
- [P 1.0] :
- [ t 1.5] :
- [P 1.5] :
- [ GEn] :
If [ Gen] is selected, another display identified with the letter K appears in order to set the
number of impulsion / litre
Notes:
If parameters system capacity (C), water hardness (H) or reserve (S) have just been modified
during programming, the circuit board recalculates the system capacity.
23
10 min
60 min
12 min
Regeneration Cycles
1. BW Backwash
2. BD Brine draw
3. RR Rapid rinse
4. BF Brine fill
Turbine meter 3/4"
Wheel meter 3/4"
Turbine meter 1"
Wheel meter 1"
Turbine meter 1 1/2"
Wheel meter 1 1/2"
Other meter than Fleck®
ELECTRONIC SXT
E
N
G
L
I
S
H