Special Features; Troubleshooting - RIB NOVA Wi-Fi Manual Del Usuario

Fotocélulas sin cables
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

G
B
- Place the jumper JP4 on the transmitter in the following position to enable the
strip:
- Place the jumper JP3 on the transmitter in the following position to control the
N.O. contact:
S
PECIAL FEATURES
WITH THE NOVA Wi-Fi RECEIVER IT IS POSSIBLE TO MAKE THE
PHOTOCELL FUNCTION AS A SENSOR BY USING THE JUMPER JP7.
Perform the following procedure:
- Remove the NOVA Wi-Fi receiver battery.
- Cut the jumper JP7.
- Replace the battery.
- Perform memorization on the MASTER Wi-Fi
- If the photocell has already been memorized, perform a single cancellation of
the previously memorized position, and then proceed to memorize using the
new configuration.
IF THE PHOTOCELLS ARE NOW INTERCEPTED, THEY WORK AS A SENSOR
BOTH IN OPENING AND IN CLOSING.
This function protects the area not used for pedestrian and not vehicular traffic
(the motion area of the door when opening or the area between the door panels
and the side walls to which they open) to protect individuals who may be present
in these areas.
T
ROUBLESHOOTING
The green LED DLTX of the transmitter does not come on when the
battery is inserted.
The red LED DLRX of the receiver does not come on when the battery is
inserted.
The MASTER Wi-Fi buzzer emits a sound every 3 seconds for 1 minute
and the door continues to function.
The MASTER Wi-Fi buzzer emits an intermittent sound for 1 minute, and
the door does not move.
The door does not open.
The door does not open, the buzzer emits an intermittent sound and one
of the dual-colored LED turns on alternating red to green.
The sensor connected to the transmitter or receiver does not act as a
safety device.
Pushing the sensor with an N.O. contact connected to the receiver, the
buzzer emits 5 consecutive sounds.
Pushing the sensor with an N.C. contact connected to the receiver, the
buzzer emits 5 consecutive sounds.
PROBLEM
JP4
JP3
JP7
Check that the polarity of the batteries is correct, or
replace exhausted batteries
Check that the polarity of the batteries is correct, or
replace exhausted batteries
Replace the batteries of the photocell(s) as they are low.
Replace the batteries of the photocell(s) as they are low.
The photocell is not aligned, stuck or the transmitter has exhausted
batteries, or
Resistance of 8,2 kΩ is not connected in series to the N.C. contact or in
parallel to the N.O. contact of the strip connected to the transmitter or
receiver.
The NOVA Wi-Fi receiver batteries are exhausted.
Check that the jumpers on the NOVA Wi-Fi transmitter or receiver have
been positioned correctly.
Jumper JP8 is configured as an N.C. contact, place it on N.O.
Jumper JP8 is configured as an N.O. contact, place it on N.C.
18
18
18
18
CHECK

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Acg8037Nova acg8037

Tabla de contenido