RIB VERTIGO WIRELESS Serie Manual Del Usuario página 14

G
B
INFRARED SIGNAL TRANSMITTER - TX
ASSEMBLY OF THE INFRARED TRANSMITTER
- Separate the cover with the rubber support (1) from the base (2) and remove the electronic
board (3) (Fig. 2).
- Place the base (2) on the lower border of the leaf of the gate and fasten it immediately
using 2 self-tapping screws TCCR3,5X16 supplied (4).
- Check that the gasket is present and it is intact within the cover (1).
- If necessary, rotate the bellows assembly which includes the lens by 90°, so to direct the
infrared ray as per need (VERTIGO WIRELESS comes with the infrared ray set as per Fig.
2). It is possible to direct the ray according to the needs:
- Insert the electronic board (3), linked to the cover with the bellow, in the special rails on
the base (2).
- Insert the batteries paying attention to the polarity (Fig. 4).
- When the batteries are inserted into the transmitter the DLTX green led (Fig. 1) lights on
for 10 seconds, indicating the proper functioning.
The led then switches off to avoid consuming the batteries energy, but the transmission of
the infrared signal remains active.
- Assemble the cover (1) attaching it to the base (2) on the top part using the special tooth
and then close the cover.
- Once the cover is closed, check that it is parallel to the base. Otherwise, open it again and
check that the circuit and the connection wires are correctly fitted in their seats.
- Fasten the cover (1) to the base (2) with the 4 self-tapping screws TCCR2,9X9,5 supplied
(5).
TRANSMITTER
SETTINGS AND CONNECTIONS
DLTX Green LED function indicator
DIP 1 ON
SWTX
DIP 2-6 OFF
BAT Alkaline batteries
2 x AA 1,5V
J1 Connector
for connecting the
transmitter diode
2
14
TX
TX
3
DLTX
SWTX
BAT
J1
1
+
-
4