RIB VERTIGO WIRELESS Serie Manual Del Usuario página 15

INFRARED SIGNAL RECEIVER - RX
ASSEMBLY OF THE INFRARED RECEIVER
- Separate the cover with the rubber support (7) from the base (8) and remove the electronic
board (9) (Fig. 5).
- Remove the lid doing pressure with a screwdriver and insert the conduit supplied.
- Place the base (8) on the upper border of the leaf of the gate (at a maximum distance of
3 metres from the transmitter).
- Fasten it immediately using 2 self-tapping screws TCCR3,5X16 supplied (10).
- Check that the gasket is present and it is intact within the cover (7).
- If necessary, rotate the bellows assembly which includes the lens by 90°, so to direct the
infrared ray as per need (VERTIGO WIRELESS comes with the infrared ray set as per Fig.
5). It is possible to direct the ray according to the needs:
- Insert the electronic board already mentioned, linked to the cover with the bellow, in the
special rails on the base.
- As power supply is given to the receiver the DLRX red led (Fig. 4) lights on indicating the
proper functioning.
RECEIVER
SETTINGS AND
CONNECTIONS
J3 Connector
for connecting the
receiver diode
DLRX Red LED indicating
correct power and
infrared signal alignment
J4
Terminal block
AD+ Power Supply 12-24V ac/dc
AD- Power Supply 12-24V ac/dc
COM Contacts' common
EDGE Normally closed contact NC
5
15
RX
RX
G
B
J3
DLRX
J4
4
6