Pahlen Jet Swim Motion Manual Del Usuario página 13

Jet Swim Motion
Installation in Thick Pool Walls
Thick pool wall with liner
N.B.! Any reinforcement present must not be closer than 50 mm from stainless steel material.
The pool wall must be done being polished before any constituent parts are installed.
1.
Connect the start hose to the niche.
3. Attach all socketing pipes in the recess. All threads must be tightened with thread tape.
4.
5.
Install the pool liner with water up to 5 cm under the house.
5 Nm in torque, the screws must be lubricated.
Cut away the pool liner against the inside of the clamping ring.
9.
10. Connect the hose for the air admixture and tighten the hose clamp. Attach the other opening of
the hose 100 mm above the surface of the water, behind the pool wall.
11. Connect the start hose
Connect pipes and valves to the pump. All threads must be tightened with thread tape.
Concrete pool without liner
Concrete pool with tiles/mosaic:
Painted concrete pools: Do not require the above step.
1.
N.B.! Reinforcement present must not be closer than 50 mm from stainless steel material.
Connect the start hose to the niche.
3. Attach all socketing pipes in the niche prior to moulding. All threads must be tightened with
thread tape.
4.
5. Connect the hose for the air admixture and tighten the hose clamp.
Attach the opening of the hose 100 mm above the surface of the water, behind the pool wall.
Connect the start hose
Connect pipes and valves to the pump. Threads are sealed with thread seal tape.
to the control box.
to the control box.
13
EN S
Sample image:
1. Niche
4. Self-adhesive gasket
5. Gasket
9. Screw
10. Front
11. Screw
14. Liner
UP
A
Figure 1.2
Niche seen from the front.
Sample image:
concrete without liner
1. Niche
4. —
5. —
9. Screw
10. Front
11. Screw
13. Polish
15. Gasket
A