Electrical Installation; Electrical Connection Diagram - Pahlen Jet Swim Motion Manual Del Usuario

Jet Swim Motion

Electrical Installation

All electrical connections shall be made by an authorised electrician.
The device shall be preceded by a residual current device with a maximum breaking current of 30 mA. The pump motor is
connected via the control panel for Jet Swim Motion, see the circuit diagram. Check the rating plate on the pump motor for the
correct connection on the closing link.
can damage the pump.
Make sure that the motor guard in the control panel is set according to the rated current; see pump's the rating plate.

Electrical Connection Diagram

3~400V
2,5~D
B1
P K1
Pressure
switch
F1
M1
Start
1. Make sure that the pump's direction of rotations is consistent with the arrow
on the motor's fan cover.
Open the valves.
3. Make sure that all the valves to and from the pump are open.
4. Start the pump.
Operation
1.
3.
N.B!
Connector
circuit relay
M
Never run the pump dry, as that can damage the parts inside.
3~230V
Circuit
breaker
Pressure
switch
A
14
EN
Connector
circuit relay
M
M
B
Air adjustment
S