Optica 665 Manual De Instrucciones página 23

COMPONENTS
the hood consists of the following elements
(Fig. 1):
1. Hood body with a glass [c], equipped
with lights and the fan unit,
2. the decorative cover consisting of the
top funnel [a] and the bottom funnel [B],
. Wall hanger of the hood [D] and the
hanger of the top decorative cover [E],
. air exhaust guide [F],
5. Set of mounting plugs.
INSTALLATION
to install the hood proceed as follows:
1. install the wall hanger [D] at the appro
priate level.
2. Hang the hood body [a] on the hanger [D]
. connect the hood to the ventilation duct.
. connect the hood to the power network.
5. install the wall hanger [E] at the appropri-
ate level.
6. install the telescopic column of the
masking cover.
INSTALLATION Of ThE wALL hANGER
a) trace a vertical line on the wall to indicate the center of the cooker plate,
b) Hold a hood hanger profile [D] to the wall (Fig. ), set it symmetrically in relation to the central
line, with the distance between the holes in the profile and the cooker plate amounting to
min. 970 mm, level the profile preliminarily, indicate the spacing of mounting holes on the wall,
c) Drill the holes as indicated on the wall, using drills of diameter corresponding to the attached
expansion plugs, drive the plugs in and then screw the hanger profile to the wall,
English
2