Attaching Cutting Tips; Release The Pressure In Unconnected Hoses And Tools (Core™ System) - Holmatro SP 52 Serie Manual De Instrucciones

EN
To replace the default spreading tips by the spare spreading tips:
• Make sure that the spreading arms are slightly open.
• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the new spreading tip onto the spreading arm (C).
• Check that the spreading tip is properly locked by the lock pin.
• Repeat the action for the second spreading tip.
5.9

Attaching cutting tips

See Fig. 9.
Cutting tips make it possible to use the spreader for cutting steel plate (St37) not thicker than 4 mm.
Cutting tips can be ordered if desired.The cutting tips are placed on the spreading arms instead of the
spreading tips.
• Make sure that the spreading arms are slightly open.
• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the cutting tip (D) onto the spreading arm (C).
• Check that the cutting tip is properly locked by the lock pin.
• Repeat the action for the second cutting tip.
5.10 Release the pressure in unconnected hoses and tools (CORE™ system)
Temperature differences can cause overpressure in unconnected hoses and tools. This overpressure
can make it impossible to connect the system. You can use the pressure relief tool to remove this
overpressure. This accessory is available for the CORE™ system and is supplied with every pump as a
standard.
NOTICE
We recommend to keep more than one of these tools at hand.
See Fig. 10.
• Hook the pressure relief tool over the male coupler (1).
• Turn the knob clockwise (2) to release the pressure. Some oil will be released.
• Turn the knob counterclockwise (3).
• Remove the pressure relief tool from the coupler (4).
6 Use
6.1 General
The equipment of a rescue system must always be ready for use. That means the equipment must be
checked and inspected directly after use, before it is put away.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use of
all equipment of the system you are going to work with.
Never try to connect or disconnect hydraulic couplers if the equipment is being used or if the
system is under pressure.
36 916.001.563_000 SP 52** (CL)