Connection Test; Operation - Alpha IP WTHP 61001 Serie Manual Del Usaurio

Operation

6.1.10 Connection test

During this verification the room control unit Display sends a switching command
to the base station. Depending on the switching status the assigned heating zone
has, it will be switched on or off after receiving the command.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol " " and confirm the selection by shortly pressing the setting
wheel.
7 Operation
The setting wheel (see position E in fig. 1) provides the operating functions of the
room control unit. The settings are transmitted to connected radiator thermostats
as well as to the Alpha IP app, and displayed there.
• Temperature: Turn the setting wheel to the right or to the left in order to
change the temperature. In automatic operation, the set temperature remains
until the next switch-over point is reached. After that, the set heating profile
will be re-activated. In manual operation, the temperature remains until the
next manual change is made.
• Manual and automatic operation: Press the setting wheel for 3 seconds in
order to change between manual and automatic operating mode. In automatic
operation, the heating profile set with the Alpha IP app is active. In manual op-
eration, the temperature can be set at the device or using the app, and remains
until the next manual change is made.
52