Technical Information; Drilling Dimensions - Webasto SmarTemp Control Instrucciones De Operación Y Instalación

SmarTemp Control
 Time & Date
 Offset
 Default
 SW Version
Back

Technical Information:

– Rated Voltage: 12 / 24V
– Operating Voltage Range: 12V: 11 – 16V | 24V: 21 - 32V
– Low Voltage Disconnect Range: 12V: 11 – 12.5V | 24V: 21 – 25.5V
– Operating Temperature: - 40° ... +185 °F (- 40° ... +85 °C)
– Set Temperature Range: 41° - 95° F (5° - 35° C)
– Installation Dimensions: (L x H x D) 2.7" x 2.2" x .60" (69.4mm x 55.5mm x 15.2mm)

Drilling Dimensions

Use the dimensions / template located in the back of this manual as a guide when installing and
mounting the Webasto SmarTemp Control.
NOTE: The Webasto SmarTemp Control has an integrated ambient temperature sensor. To ensure
this sensor properly measures the surrounding air, the control must be mounted vertical only.
Set time and date using the rotary knob and selection button.
12 (AM / PM) or 24 hour available.
Depending on the installation location, the temperature
reading may vary slightly. The Offset feature allows a
temperature adjustment of +/- 9°F (+/- 5°C). Adjust this as
necessary to obtain the most accurate ambient temperature
reading.
Default allows the user to perform a factory reset of the
control settings.
NOTE: Heater information will NOT be affected.
This displays the firmware version of the Webasto SmarTemp
Control.
Select this to return to the previous screen.
Installation - Operating Instructions
5
12 hour
0°
N/A
Installed
Version
N/A