Top Option; Ascii Rs232 Or Rs485 Output Option; Temperature Option - Gorgy Timing LEDI Guia Del Usuario

Ocultar thumbs Ver también para LEDI:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.1.7. tOP option

Connect the cable on the both wires outgoing from the clock: brown wire and white
wire
static relay output: no polarity
ttL 50 ohms output: brown wire is GND, white wire is positive impulse
sine wave output 1000Hz: brown wire is GND, white wire is frequency

3.1.8. aSCII RS232 or RS485 output option

Connect the asCii Rs232 or Rs485 code on the terminal plug following the table
below:
aSCII 1 plug
BaSCII 2 plug
GnD plug
After connecting the ASCII code, press « reset » button on the rear of the item.

3.1.9. temperature option

wire the temperature sensor on the both terminals marked : probe t°C of the termi-
nal (no polarity).
temperature probe is provided with a 4 meters cable, this cable might be extended
(25 meters length maxi.)
In case of an indoor temperature display, the sensor must be placed
between 1.5 to 2 meters from the ground and as far as possible from any
In case of an outdoor temperature display the sensor must be
placed under a ventilated shelter, to avoid the influence of solar radiation
In case of a pool temperature display, the sensor must be placed below
In wireless version, the radio transmitter must be placed out of the
water. 1000m maximum distance of transmission (distance can be reduced
MDE-LEDI-1099V3.2
aSCII RS232C
txD
RxD
GnD
heat source.
(greenhouse effect).
the surface of water.
by impediment presence)
aSCII RS422/485
E / S -
E / S +
GnD
59

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ledi reverso

Tabla de contenido