Niagara ECO IQ N9195 Instalación E Instrucciones De Operación página 13

CUSTOMIZING THE PROGRAM
1. Set the System switch to the HEAT or COOL position and the Fan switch to either the AUTO or ON position.
NOTE: In AUTO, the system blower will run only when the A/C or heat is running. In ON, the system blower will
operate continuously.
2. Depress the PROGRAM key. LCD will display an image similar to the following.
The set point temperature will blink and the time will be displayed.
3. Use the red/blue arrow keys to select the set point temperature for the Morning program Mon – Fri.
4. While the temperature is still blinking, press the TIME/DAY key to set the time for the Morning program. The time in
the LCD will blink. Use the red/blue arrow keys to select the correct time.
5. Set the remaining Day, Evening, and Night times and temperatures for the Mon – Fri. and Sat/Sun periods:
• Depress the PROGRAM key to select the desired period.
(Each depression of this key cycles the menu to the next period.)
• Depress the Time/Day key to switch between time settings and temperature settings at each period.
• Use the red/blue arrow keys to increase/decrease the time and temperature settings.
• The settings are automatically stored 15 seconds after the last touch of a key. NOTE: If the programming at any
period is not completed and the display stops blinking, depress the PROGRAM key as necessary to cycle back
to the desired period to be programmed.
• This procedure is required for both the COOL and HEAT system settings
INSTRUCTIONS
Set point temperature blinking.
13