Gaggenau VG 295 220 CA Manual Del Usuario página 14

en-us
Conversion to another type of gas
Adjusting the gas valves
9
WARNING
Risk of damage!
Do not over-tighten the bypass screws.
If necessary, adjust the bypass screws M using a Torx
screwdriver (see table):
up: The bypass screws must be flush with the top edge of
the frame.
down: The bypass screws must be screwed in fully.
Assembly:
1.
Connect the connection cable on the back of the
control panel.
14
2.
Put the cooktop in place and tighten the screws
uniformly.
3.
Put the burner parts and pan supports in place,
making sure they are positioned correctly.
4.
Attach the control knobs.
Check that the appliance is working after conversion:
Yellow tips must not be visible on the flames. When
turning the control knob quickly between the highest and
the lowest setting, the burner must not go out and
flashback must not occur.
Note: Attach the sticker showing the new gas type next to
the rating plate on the appliance.
Save the nozzles removed from the appliance for future
use.