Do These Procedures When You Begin Your Work Period - Clarke FOCUS Rider Scrubber Serie Libro De Instrucciones

ENGLISH
EN
How To Operate the Machine (cont.)
To traverse the machine follow this procedure:
1. Sit on the driver seat.
traverse if the operator is not properly seated.
2. Turn the key switch to the "ON" position.
3. Raise the brush to the highest position (if
necessary).
4. Raise the squeegee (if necessary).
6. Gently press the foot pedal and the machine will
begin to move.
7. To stop, release pressure on the foot pedal.
8. To travel in reverse, select reverse with the forward/
reverse switch.
9. To stop, release pressure on the foot pedal.
10. When you stop the machine, turn the key switch
"OFF" and remove the key.
Do These Procedures When You Begin Your Work
Period
1. Make sure the key switch is in the "OFF" position.
2. Disconnect AC power from battery charger (follow
charger instructions).
3. Make sure the filter screen (1) to the vacuum motor
is clean and installed properly in the recovery tank
(see figure 30).
4. Make sure the recovery tank lid is in place and has
been tightened (see figure 31).
5. Close and secure the lower cleaning port cover (if
so equipped) on the recovery tank.
6. Make sure that the plug in the recovery drain hose
is in place and has been tightened (see figure 32).
7. Make sure that the brushes/pads are in position
and installed correctly.
8. Make sure the brush housings are in position on
the brush head.
9. Check the installation of the squeegee and
squeegee hose.
Page -20-
NOTE: The machine will not
Figure 30
Figure 31
Figure 32
Clarke ®
Operator's Manual (EN) - Focus Rider