Powermate ® Care - Kenmore 125.22614610 Manual De Uso

Always follow all safety precautions when performing maintenance on the PowerMate
WARNING
Electrical Shock Or Personal Injury Hazard.
AlwD\V WXUQ Rç DQG XQSOXJ vacuum cleaner before performing maintenance to the
vacuum cleaner. Failure to do so could result in electrical shock or personal injury from
vacuum cleaner suddenly starting.
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
®
3. Turn PowerMate
right side up. Press
handle release
pedal and lower
the swivel. Lift
rear and side
latches up.
5. Lift agitator
assembly out
and remove
worn belt.
6. Check and clean end cap areas. See TO
CLEAN AGITATOR (page 22) section and
AGITATOR ASSEMBLY illustration (page 22)
for picture of complete agitator assembly.
POWERMATE
1. Turn PowerMate
upside down.
2. Unscrew two (2)
®
PowerMate cover
screws.
Rear
Side
Latches
Latch
4. To remove cover,
grasp the sides and
pull out.
Base
End Cap
®
CARE
TO REPLACE BELT
®
1. Install new
belt over
motor drive,
then over
belt path.
3. Line up front
of cover and
base. Rest
cover on front
edge of base as
shown.
Side
Rear
Latch
Latches
Make sure there is no gap between the
cover and base.
5. Turn PowerMate
place two (2) cover screws.
- 21 -
®
Motor
Drive
Belt
Path
Agitator
End Cap
NOTE: See PARTS
AND FEATURES
(page 5). for Belt
number.
2. Push agitator
assembly back
into PowerMate
Base
Cover
4. Rotate cover
back. Press cover
oUPO\ XQWLO VLGH
and rear latches
snap into place.
®
upside down and re-
.
®
.