Starting And Stopping The Fan - BIG ASS FANS SmartSense Guia De Instalacion

Starting and stopping the fan (Powerfoil
Powerfoil X3.0, and Powerfoil
®
The Powerfoil X Series fans are pre-configured at the factory to accept dual control sources.
®
The wall controller keypad allows you to toggle these sources easily using the LOCAL/REM
button. When the LOC indicator is illuminated on the fan's wall controller, the Start, Stop, and
Speed functions are controlled solely by the fan's wall controller. When the REM indicator is
illuminated, the fan speed is controlled by the SmartSense wall controller.
To start the fan, press the RUN button on the auxiliary controller. After starting the fan,
switch to REM mode to utilize the wall controller. To stop the fan, the LOCAL/REM button
must be pressed again for LOC mode to reactivate the STOP/RESET button.
REM Illuminated
(auxiliary controller)
WD REV REM
LOCAL
DE
REM
Green RUN button disabled
Red STOP/RESET button disabled
Up and Down arrow buttons disabled
Basic 6 , Powerfoil
®
The fan controller will operate in the same manner as it did prior to installing the
SmartSense.
The RUN and STOP buttons are still enabled for fan
operation.
RUN STOP
These buttons are now disabled for speed selection.
Essence fans
®
The Essence wall controller is not used when SmartSense is installed. Start/Stop for the fan can be accomplished
by using a switch inline with the AC power to the fan.
OPERATING SMARTSENSE
X3.0 Plus fans)
®
LOC
8, and Powerfoil
®
WWW.BIGASSSOLUTIONS.COM
X2.0, Powerfoil
®
LOC Illuminated
(auxiliary controller)
WD REV REM LOC
LOCAL
DE
REM
Green RUN button active
Red STOP/RESET button active
Up and Down arrow buttons active
8Plus fans
®
© 2015 DELTA T CORP. ALL RIGHTS RESERVED.
Wall Controller
X2.0 Plus,
®
Back
10% MAXIMUM FAN SPEED 100%
55°F THRESHOLD TEMPERATURE 100°F
WINTER MODE
SUMMER MODE
MANUAL
MODE
Front
23