Description of the appliance
Mist outlet (rotating)
Hydro Cell
Evaporation chamber
Water tank
Demineralization cartridge
Water tank cap
Brush
Water base
Control panel
Main body
Water level sensor
Membrane
Power plug
Air inlet
Setting up
Finding the ideal location for your unit:
• Do not place the humidifier directly next to a heating
vent or on a floor with floor heating. The moisture of
the mist can damage the floor surface (6) (see Safety
Instructions).
• The unit should be placed in an elevated position (7),
e.g. on a table, chest, etc. at least 3 ft off the floor.
• The mist outlet must not be pointed directly at plants,
furniture, or other objects (13). Keep distance of at
least 20 inches (50cm).
• Soak the demineralization cartridge in a water bath
24 hours before using it (14). The resin has to absorb
water to reach maximum performance. If it is soaked in
the tank, make sure to exchange the water and empty
the water from the base before using the humidifier.
• On average the demineralization cartridge should
be replaced every 2 – 3 months depending on your
water hardness. Some areas may need to replace the
cartridge sooner, some may last longer. The cartridge
must be exchanged at the latest after 6 months or the
unit does not reach its full performance anymore.
See «Replacement of the demineralization cartridge».
• Read the instructions under «Filling the Tank» for
adding water in the humidifier (15 and 16).
• Place the water tank onto the base.
• Insert the plug into the socket and switch on the
appliance using the on/off button (19).
• About 10 to 15 minutes after it is switched on the
device will reach its full output level.
• Make sure that the cable is not pinched anywhere (9).
Do not operate the humidifier if the cable is damaged
(2).
13
14
en
24 h
9