Installation; Television Location; Optional Cable Connections; Ac Power Supply Cord - Panasonic PT-53WX54 Instrucciones De Operación

Monitor de proyección de alta definición
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

Television Location

This unit can be used as part of an entertainment center.
your dealer for available options.
Avoid excessive sunlight or bright lights, including
reflections.
Keep away from excessive heat or moisture. Inadequate
ventilation may cause internal component failure.
Fluorescent
lighting
transmitting range.
Keep away from magnetic equipment, including motors,
fans and external speakers.

Optional Cable Connections

Shielded audio and video cables should be used between
components. For best results:
Use 75-ohm coaxial shielded cables.
Use appropriate input and output connectors, that match
your component connectors.
Avoid long cables to minimize interference.

AC Power Supply Cord

CAUTION:
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT
OF AC OUTLET AND FULLY INSERT. DO NOT
USE A PLUG WITH A RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED
OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT
FROM THE APPARATUS.

Cable / Antenna Connection

For proper reception, either a cable or antenna connection
is required.
Cable Connection
Connect the cable supplied by your local
cable company to ANT1 connection on
back of television. Select ANT1 and Cable
mode in SET UP menu.
Note:
A cable converter box may be
required
for
proper
Check
with
your
company for compatibility requirements.
Antenna Connection
For proper reception of VHF/UHF channels, an external antenna
is required. For best reception an outdoor antenna is
recommended.
Connect home antenna to ANT1
connection on back of television.
Select ANT1 and TV mode in the
SET UP menu.
Note:
Cable Mode is preset at the
factory.
Antenna
change to TV Mode and ANT 1 in
the Set Up menu.
Consult
may
reduce
remote
control
Polarized plug
Incoming Cable from
Cable Company
75 Ohm VHF/UHF
on back of TV
reception.
local
cable
Incoming Cable from
Home Antenna
users
must

Remote Control Battery Installation

Requires two AA batteries (supplied)
1
3
Procedure
1. Turn the remote control face down. Remove battery
cover by pressing down on the marking on the cover
and sliding it off in the direction indicated.
2. Install batteries matching (+) and (-) polarity signs.
3. Replace the battery cover by sliding in reverse until the
lock snaps.
Note:
Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control.
Precautions
Replace batteries in pairs.
Do not mix battery types (zinc carbon with alkaline).
Do not recharge, heat, short-circuit, disassemble, or
burn batteries.
I
NSTALLATION
.
Battery Polarity
2
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pt-47wx54Pt-47wx34

Tabla de contenido