Descargar Imprimir esta página

Ubbink MultiBright Float 3 LED Manual Del Usuario página 2

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 6
1 MultiBright Float 3 LED
The MultiBright Float 3 LED are fl oating spherical lights. For low voltage use, includes transformer.
Read these instructions for use thoroughly before taking the lights into use.
Nominal voltage
Lamp
Transformer
Cable length
Nominal power
Guarantee
Includes
Safety instructions
• The pond fl oodlight must be connected to a network with 230 VAC/50 Hz via a safety transformer according to the requirements of the harmonised EU-Directives, EU-Safety
standards and product-specifi c standards. Possibly ask your local utility regarding connection regulations.
• The safety transformer used must be connected to an outside safety socket with earth (IP X4) at a distance of at least 3.5 m from the pond.
• The connected bulb capacity must not exceed the rated capacity of the safety transformer! A too high load may damage the transformer beyond repair. Only a safety transformer
recommended for this should be used for correct operation of the pond fl oodlight.
• The pond fl oodlight is intended for underwater use. Pay attention that the fl oodlight is always fully submerged in the water to guarantee suffi cient cooling of the fl oodlight.
• Do not use the cable for carrying the pond fl oodlight and never pull at the cable.
• The electric cable cannot be replaced. If the cable is damaged, the pond fl oodlight must not be used any longer and must be correctly disposed.
• The power supply must always be disconnected during assembly and disassembly of the pond fl oodlight and during maintenance work.
• The device is not suitable for usage by persons (Including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless supervised by
a person responsible for their safety or they have been instructed in the usage of the device. Children must be supervised to ensure that they are not playing with the device.
Instructions for use
The power must always be disconnected when assembling, disassembling or maintaining the equipment.
Ensure that the lower cover is never screwed onto the sphere at a slant.
Check that the voltage from the transformer and the voltage to be used correspond.
The electrical cable cannot be replaced. If the cable is damaged, the equipment may no longer be used.
The socket to which you connect the transformer must always be placed behind an earth leakage circuit breaker with a nominal just-operate current of 30mA. The nominal just-
operate current must be stated on the earth leakage circuit breaker in the meter cupboard. In case of doubt, ask your electrician.
Installation
To install or replace the LED lamp, twist the black base of the sphere, after the power has been disconnected. Make sure that the O-ring stays in the correct position in the base. Then
carefully pull the transparent cover out of the rubber holder. Place the LED lamp in the fi tting (do not touch it directly with your hand). Then twist the base back on to the sphere.
Cleaning
Repeat the same process as for changing the bulb. Use only water and a soft brush. Ensure that no moisture gets into the fi tting!
Repair
It is not possible to repair the cable, housing or transformer if these become damaged. The product must then no longer be used and should be destroyed.
Guarantee
We give a 2-year guarantee from the date of purchase on materials and manufacturing defects for this product. To make a claim under this guarantee, the original invoice
must be submitted as proof of purchase. Claims brought about by incorrect installation or operation, inadequate maintenance, the eff ects of frost, inexpert attempts at repair, the use
of force, wrongful acts by a third-party, overloading and foreign objects, as well as all damage to parts resulting from wear and tear, are not covered by this guarantee. By virtue of the
Product Liability Act, we are not liable for damage caused by our equipment, if this is the result of inexpert repairs.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Manual multribright float 3 led a5.indd 2
230VAC-50Hz
LED G4 12VAC - 24SMD
230VAC/12VAC 6 VA
5 m
3 x 1,5W
2 years
transformer for outdoor use (IPX4)
26-10-15 10:42

Publicidad

loading