Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION SHEET FOR FEDERAL SIGNAL STREAMLINE
Failure to follow all safety precautions and instructions may result in property damage,
SAFETY MESSAGE TO INSTALLERS, USERS, AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is to be installed by
a trained electrician who is thoroughly familiar with the National Electrical Code and will follow
the NEC Guidelines as well as local codes.
This device may be considered a part of the signaling system and not the entire signaling system.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the facilities engineer. In addition, listed below are some
other important safety instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this equipment.
• Do not connect this light to the system when power is on.
• After installation, ensure that all screws and threaded joints are properly tightened.
• After installation, test the light system to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction sheet to all operating personnel.
• Establish a procedure to routinely check the light installation for integrity and proper operation.
• To prevent potential danger to persons or damage to production equipment resulting from a
failure or fault of the signaling device, additional safety precautions (limit switch, protection
device, etc.) are necessary.
I. INSTALLATION.
A. Unpacking.
After unpacking the equipment, examine it for damage that may have occurred in transit. If the
equipment has been damaged, do not attempt to install or operate it. File a claim immediately
with the carrier stating the extent of the damage. Carefully check all envelopes, shipping labels
and tags before removing or destroying them.
B. Mounting.
The Streamline
control panel. It may be installed on machines, control boards, or any installation where
surface mounting is required. Make sure that the surface is even and there is sufficient room
to install the light before mounting (see figure 2 for dimensions).
1. Drill a mounting hole with a diameter of 39mm (1.54 in) on the inside surface of the panel
housing. Refer to figure 1 for drill template.
2. Refer to figure 3. Remove the hexagon nut and install the LP2 light on the outside surface
of the panel housing. The rubber seal should be placed between the light and mounting
surface. Replace the hexagon nut and screw tightly onto threads.
The hexagon nut and rubber seal must remain on the light unit to provide a good seal and prevent
LIGHT MODEL LP2
SAFETY NOTICES
serious injury, or death to you or others.
™
Model LP2 light is designed for installation on a flat surface, such as a
damage to the light.
WARNING
NOTE
1
™
LOW PROFILE
Publicidad
