Installation; Preliminary Information - Henry Schein HEATSEALER 2000 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

INSTALLATION

PRELIMINARY INFORMATION

The HEATSEALER 2000 thermal sealer has been tested at the factory.
On receiving the sealer control that the packing is whole and keep it in case it should be shipped.
Open the packing and control that the delivery corresponds exactly to the technical specifications and
that no apparent damage is present.
In case of damage or missing parts inform the forwarder, HENRY SCHEIN and its area agent immedi-
ately.
TO INSTALL THE EQUIPMENT FOLLOW THESE INSTRUCTIONS
1. Place the sealer on a flat surface and with
enough room around to be ergonomically
operative.
2. Do not install the sealer next to sinks or the like,
to avoid contact with water and a consequent
short-circuit of the electrical part.
3. Do not place the appliance near heat sources.
4. Install the machine in a room with normal air
circulation.
5. Check that the power supply cable is not bent
and is free up to the plug.
6. In case of model provided with roll-holder, insert
the supports of the roll-holder into their slots,
then fit in the roll on the supports.
7. Insert the power plug, and the sealer is ready.
WARNING
The first sealing operations could produce a slight smoke and an unpleasant smell. This fact, due
to substances used on assembling the machine, is temporary and will disappear after a few seal-
ing operations.
6
HEATSEALER 2000

Publicidad

Tabla de contenido
loading

Productos relacionados para Henry Schein HEATSEALER 2000

Tabla de contenido