Adjustments; Troubleshooting - Henry Schein HEATSEALER 2000 Instrucciones De Uso

ADJUSTMENTS

Usually HEATSEALER 2000 Thermal Sealer does not require any adjustment.
Because of variety of envelopes and bags on the market, the equipment is provided with a device for the
temperature adjustment.

TROUBLESHOOTING

The power green light stays off
The protection canvas on the resistor is burnished
or burnt
The paper is nor clearly cut
The Sealer seals but the yellow light stays off
The heating element smokes or sends out a bad
smell
The envelope sealing is not satisfactory
The envelope sealing is burnished (or burnt)
The sealer is provided with a device for temperature control and a safety thermal fuse.
In case of mains voltage surge or improper use, the fuse will burn or wear off so that it has to be replaced.
If the fuse is burnt, call the service for a replacement or send the appliance directly to the nearest service
centre.
We mark that the function of the fuse is for protecting the thermal sealer from possible worse and more ex-
pensive damage and that the fuse is a specific element required by the safety standards.

USE ONLY AND EXCLUSIVELY ORIGINAL SPARE PARTS AND APPLY TO AN AUTHOR-
ISED TECHNICAL SERVICE CENTRE
HENRY SCHEIN is not responsible for any faults or damage caused by appliances tampered with by non
authorized personnel or in case of fault of parts that are not original.
HEATSEALER 2000
Problem Solution
Check the electrical plug
Check the fuses
Call the service
Call the service for the replacement
Replace the cutter or call the service
Call the service for the LED replacement
If the problem persists after the first few sealing
operations, call the service
Increase the temperature by turning the potenti-
ometer on (by the adjustment key)
Decrease the temperature by turning the potenti-
ometer down (by the adjustment key)
9