Handling And Transport - Palazzetti MULTIFIRE NT ARIA Manual De Instalación & Mantenimiento

4 HANDLING AND
TRANSPORT
The stove is delivered complete with all parts
included.
Beware of the tendency of the stove to tip over.
When lifting avoid jolts or sudden movements.
Make sure that the forklift capacity exceeds the
weight of the stove being lifted.
The operator of the forklift or other hoisting
equipment is responsible for lifting the loads.
Prevent children from playing with the packaging
components (e.g. film and polystyrene). Danger of
suffocation!
4.1 REMOVING THE STOVE FROM THE
PALLET
To remove the stove from the transport pallet follow
the instructions shown in the "Product Booklet".
5 INSTALLATION
5.1 GENERAL INFORMATION
The following paragraphs provide instructions that
must be complied with in order to ensure maximum
efficiency of the product purchased.
The following instructions are however subordinate
to compliance with any national, regional and local
laws and standards in force in the country where
the product is installed.
5.2 SAFETY PRECAUTIONS
Responsibility for work carried out in the place
where the stove is installed lies with the user;
the user is also responsible for making sure the
installation checks are completed.
The user must abide by all local, national and
European safety requirements.
The appliance must be installed on floors with a
suitable load-bearing capacity.
The stove assembly and dismantling instructions
are reserved exclusively for specialist technicians.
Users should always contact our service centre
to request work to be performed by qualified
technicians.
5.3 SITE FOR INSTALLATION OF THE
PRODUCT
Protect all structures that may catch fire if exposed
to excessive heat.
5.4 CASING
004776370 - 31/01/2019 - PALAZZETTI - PN - ITALY
Floors made from flammable materials such as:
wood, parquet, linoleum, laminates or carpets
must be protected by a suitably-sized fireproof
base underneath stove.
The manufacturer declines all liability for any
alterations to the characteristics of the material
making up the floor underneath the protective
base.
Any elements made from wood (e.g. beams) or
other combustible material located near the stove
should be protected with fireproof material.
Flammable walls or elements must be kept at
least 120 cm away from the stove.
Leave enough clearance for maintenance work.
Make sure the minimum distance from flammable
materials is observed, as shown on the pipes used
to make up the flue or chimney.
The unit is equipped with wheels for easy
positioning; Take care to adequately protect the
wooden floors to avoid damage.
The stove should be inserted inside a suitable
casing made of fireproof materials and will have
the following basic features (fig. 5.1):
A) adequate openings for component inspection
B) a door for access to the pellet loading tank
C) Grills for venting the heat in the hood / distance
between cladding and ceiling.
D) grilles for the entry of heating air and room fan
intake.
E) access element to the ash drawer
F) Control panel
• Make sure that between casing and stove there
is a minimum distance of at least 5 mm.
• Wooden beams must have fireproofing treatment
and be protected by screens in fireproof material.
• Minimum distance between ceiling and cladding
= minimum 10 cm, or have a heat vent area min.
of 1.68 Dm2 (equivalent to three grids measuring
40x15 cm).
• When covering the stove, it is necessary to
protect it from dust, mortar or other foreign
bodies that may damage it. Remove this
protection after completing the work.
25