Publicidad
Idiomas disponibles
Idiomas disponibles
6 Establishing a connection in "Transmission mode"
In this mode you can transmit music from devices without a Bluetooth interface
to a Bluetooth player.
First make sure that the 2in1 Transmitter/Receiver is switched off (the LED next to
the On/Off/pairing button is off).
Set the switch to position TX to activate transmission mode.
Now connect the 2in1 Transmitter/Receiver to the signal output of your music
player using the enclosed cinch connecting cable.
Hold the On/Off button on the 2in1 Transmitter/Receiver down for approx. 9 sec-
onds until the LED starts to flash blue. Now activate the Bluetooth link mode on
your receiving device such as a Bluetooth speaker. The 2in1 Transmitter/Receiver
will now automatically connect to the receiving unit.
Note: Please make sure that no other devices are in link mode when you make the
connection. How you set your receiving device to link mode is described in these
operating instructions..
7 Resetting the pairing list
To delete the pairing list in your device, you first have to switch it off. Now hold
the On/Off/pairing button down for around 16 seconds until the red and blue LEDs
both flash for one second. The pairing list has now been successfully reset.
8 Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not certified
for use in the open air; only use it in dry conditions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the device
to sudden changes in temperature or heavy vibration as this might damage elec-
tronic components.
Examine the device for damage before using it. The unit should not be used if it has
received an impact or has been damaged in any other way. Please observe national
10
English
Publicidad
